6 speed engraved shift knob GRAY: 12mm x 1.25 for 2016+ Toyota Tacoma V6
Classic round engraved 6 speed knob w/ 12mm x 1.25 thread:
Fits 2016+ Tacoma V6 (RC62F) - manual trans OE shifters
- Does NOT FIT Hurst sticks
- 2 1/8" dia ball of solid thermoset resin colored GRAY, polished
- True engraved shift pattern on top, paint-filled
- Reverse upper left
- Plain sides - no logo; this is NOT a TRD part
- Recessed brass thread mount
- Hurst jam nut included
- WARNING: jam nut MUST be used; knob will break if mounted w/o nut!
- Made in USA to our specifications by a leading knob manufacturer
- Bulk part, no retail pkg
To remove old knob - grasp chrome ring under knob and rotate 1/4 turn clockwise looking down to disconnect ring from knob, and then unscrew knob. Slide chrome ring up off of stick, insert supplied grommet into ring and slide assembly back down stick. Alternatively, remove the console panel (lift first at front, and then work toward rear; at rear under console door pry trim straight up to release), flip the boot inside out, cut the cable tie holding the ring to the boot, and then reassemble and slide boot down to larger part of stick but that is a lot of work.
To install the new knob - first thread the jam nut down as far as it will go, with recessed side up. Screw knob down as far as it will go but as soon as it stops back it off up to one turn to align the pattern (do not force further down or it will break) and then bring nut up against knob and tighten with a wrench.
We Also Recommend
6 speed engraved shift knob & boot retainer for 2005-2013 C6 Corvette w/ aftermarket 9/16"-18 shifter