Menu
Cart
Replacement Band for Hurst Button Switch to fit chrome sticks

Replacement Band for Hurst Button Switch to fit chrome sticks



*** THIS part is included in the switches we sell; do NOT buy this part unless you need a replacement or bought your switch elsewhere. ***

Upgraded, larger replacement band sleeve for Hurst Roll Control Button Switch #2483875 found in kit #1745000

  • 5/8" x 3/4" black silicone tubing, 1" long, 50A durometer
    • Slightly larger and stretchier than original
  • Easier to install, will not tear like the original EPDM rubber

Background: The original rubber band sleeve is too small and stiff to fit over Hurst chrome sticks, resulting in difficult installation and tearing. Our replacement sleeve is larger, stretchier, and more durable.

Directions: Remove switch from stick if installed. Remove phillips screw from top rear of switch housing above band. Pry / slide lower part of rear cover away from main housing, off pins (do not rotate or hinge). Slide original band off of rear cover and replace with new band. Make sure new band drops into relieved center area of rear cover and replace all parts. Apply a light oil or grease to stick and slide switch slowly down over stick to desired position.


We Also Recommend