Core Shifter w/ Hurst stick for Jeep Wrangler : 2000-2004 6 cyl (NV3550)

  • $ 29900

This item is temporarily out of stock. Click here to be notified by email when it returns

Short throw shifter kit for OE replacement on 5 speed manual trans in:

  • 2000-2002 Jeep Wrangler TJ - 4.0L 6 cyl only
  • 2003-2004 Jeep Wrangler TJ - all engines

ONLY FITS NV2550 & NV3550 manual trans specific to these models - sales codes DDD & DDK

  • Does NOT FIT 2000-2002 4 cyl models, other model years (different transmissions), or any other models
  • Base configured for shifter stub receptacle height of 3/4" as original to these models
    • IF your transmission has been serviced, it MAY REQUIRE A DIFFERENT BASE. If you install the wrong one it will not work properly and could cause damage. To confirm height, remove shifter base and measure transmission as shown in last pic

Available in two knob heights:

  • For use w/ stock body frame bushings (no spacers):
    • Stock (default); comparable to discontinued Hurst # 391040
      • Stick # 0090; 20" from base flange to top of knob; 30% throw reduction
  • For use w/ aftermarket body lift (frame spacers) = taller stick:
    • 3" higher than stock : + $20
      • Stick # 4077; 23" from base flange to top of knob; 21% throw reduction

Kit includes a Hurst chrome stick & classic knob, Core Shifters base w/ pre-installed lower pivot cup, mounting hardware, dust cover boot, and installation instructions. Bulk parts; no retail pkg. The base is built by Core Shifters using proven Hurst Billet Plus components inside a custom housing:

  • Forged heat-treated billet steel gear selector stub
  • Hardened steel cross-pin & stainless steel fulcrum pivot ring
  • Self-centering cross-gate bias springs with heat treated spring seats
  • Glass-reinforced polyamide fulcrum socket with steel wear clips
  • Rubber oil control seal with steel retaining ring
  • 6061-T6 extruded aluminum housing with Spirolox steel support ring
  • Zinc-plated laser-cut steel cover with heat-treated spring retainer straps
  • CNC-machined 6061-T6 billet aluminum base
  • Vibration-resistant serrated flange head steel retaining bolts

Complete your installation with a "HURST EQUIPPED" emblem!

We Also Recommend